SparkFun Zubehör The SparkFun Single Supply Logic Level Converter is logic level and power supply translator in one small package. This little board breaks out the Texas Instruments TXB0104 4-bit bi-directional voltage-level translator with automatic direction sensin

Raspberry Pi Hats / Add-on-Boards Feeling fancy? Why not add a Top pHAT to your Pi pHAT stack? The SparkFun Top pHAT for Raspberry Pi is intended to be at the top of a pHAT stack so you won't find any pins for stacking on top of this board but that's ok because you will want to pre

SparkFun Zubehör This is a unique two-cell AAA battery holder built specifically for the BBC micro:bit. The 6" ( 150mm) cable has been terminated with a JST-PH connector.The connector mates the JST socket on the micro:bit perfectly allowing you to easily make your p

SparkFun Zubehör USB-C is quickly becoming more and more prominent in the maker community because let s be honest who likes trying three times to insert USB into a port? This is a 16-pin female USB Type C connector that is commonly found in smart phones laptop

Kameralinsen This is the 6mm CS-mount wide angle lens from CGL Electronics Co. Ltd. for use with the Raspberry Pi HQ Camera Module. The lens produces a 3MP picture in a 0.5in image format and is easily interchangeable using the thumb screw and adapter included wi

SparkFun Zubehör If you want to get some sound out of your project but have a tight space budget this is a good way to do it. This 0.5W 8Ohm speaker is only 40mm in diameter and just over 4mm thick the same kind you might find in one of those "talking greeting car

SparkFun Zubehör This 3ft Category 6 (CAT 6) Ethernet cable is the solution to your internet working needs. With a speed of up to 500MHz you can connect to your LAN/WAN segments and networking gear at maximum speed. Also with its superior connector you get a cable t

SparkFun Zubehör 1/6th Watt +/- 5% tolerance PTH resistors. Commonly used in breadboards and perf boards these 330Ohm resistors make excellent LED current limiters and are great for general use. Need more than one? Checkout our bags of resistors.

SparkFun Zubehör Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft diffuse glow.Features:620-625nm Red1.8-2.2VDC Forward Voltage20mA Forward Current40 degree viewing angle100-150 MCD outputDocuments:[Datasheet](htt

SparkFun Zubehör This is a through-hole 12mm coin cell battery holder. It's the unit we like to use as RTC backup and SRAM backup for GPS units. Holds battery in place with friction. Metal housing is + PCB pad underneath is -.This battery holder is sold in single un

SparkFun Zubehör This is a SparkFun exclusive! These are 12" long jumper wires terminated as male to male. Use these to jumper from any female header on any board. Multiple jumpers can be connected next to one another on a 0.1" header. Comes in five packs of twenty j

SparkFun Zubehör These nylon standoffs are 3/4" long and tapped for a 4-40 screw. These are great for mounting your board in an enclosure or just getting it up off the table.Sold in packs of 10. Check below for matching screws.